Bombardier SeaDoo 1990 factory shop manual, Page 152Get this manual

Bombardier SeaDoo 1990 factory shop manual, Page 152

Section 08 PROPULSIONDRIVE SYSTEMS Sub-Section 01& DRIVE SYSTEMS) NOTEIf wear ring does not feature lip on its edge, apply
jet pump alignment will be alteredInsert drive shaft end through hull tunnel Slide through seal carrier being careful not
to damage seals Push on pump until shaft comes close to flywheel CAUTIONWhen sliding the drive shaft through seal carrier,
the double lip seal (PN 293 200 0091 could be folded overThis could cause seal rier bearing failureWhile holding pump, guide
and engage shaft splines in flywheel Rotate shaft to properly index splines Make sure boot is well postionedover shaft end
If necessary, tap pump end with rubber hammer until retaining nuts and washers can be installedApply bctite 242 (blue)293
800 015) on threadis and equally tighten nuts in criss-cross sequence and torque to 35 Nm (26 lbfft FC01 009 083 Closing