Bombardier SeaDoo 1990 factory shop manual, Page 153Get this manual

Bombardier SeaDoo 1990 factory shop manual, Page 153

Section 08 PROPULSIONDRIVE SYSTEMIS Sub-section 01 (PROPULSIONDRIVE SYSTEMS) 21,22,23,24, Screw, Sleeve BushingNozzle lnsert
during initial start Using grease gun, carefully lubricate, with synthetic grease293 550 0101, at grease fitting until boot
is just beginning to expand From this point, immediately stop Secure seal carrier protective hose hull insert with gear to
clamps Lubricate at seal carrier grease fitting until grease is lust corning out on engine side From this point immediately
stop CAUTION :Water must be supplied to cool engine with flush kit (PN 295 000 038)not Do run engine longer than five minutes
since drive line seal has no cooling out of water FOOI 008 001 Secure flywheel guard to engine studs by installing on studs