Bombardier SeaDoo 1990 factory shop manual, Page 157Get this manual

Bombardier SeaDoo 1990 factory shop manual, Page 157

Section 08 PROPULSIONDRIVE SYSTEMS Sub-section 02 (REVERSE SYSTEM) 27, Reverse Gate Spring It is not niecessary to remove
FOOZ 00s 009 1, Reverse Support Plate ASSEMBLY Assembly is essentially the reverse of disassembly procedures However pay
particular attention to the following For reverse support plate installation torque screws to N-m 471 Ibfein) 8,11, Triangular
LeverSliding Block Insert bushing to triangular lever and then install lever to reverse support Install reverse cable to
triangular lever with bushing and plastic washier which is installed to opposite side of reverse cable on reverse support
Torque screws to N-m (71 Ibf-in) Install sliding block to lever and torque nut to N-m (71 Ilbfminl 27, Reverse Gate Spring