Bombardier SeaDoo 1990 factory shop manual, Page 167Get this manual

Bombardier SeaDoo 1990 factory shop manual, Page 167

Section 10 HULLIBODY Sub-section 01 (HULLIBODY) GENERAL In the situation when the water tank trap could possibly move from
WARNINGThe fuel valve must be set "OFF"Remove fuel cap slowlyFuel may be under pressure and might spray out when removing
capFuel is flammable and explosive under certain conditionsAlways work well ventilated areaD not smoke olr in alllow open
flames or sparks in the vicinityAlways wipe off any fuel spillage from the watercraftRemove tow hook nuts NOTEIt 11snot necessary
to remove all the glue but it is important to have smooth surfaces in order to get good adherence INSTALLATION Installation
is essentially the reverse proceduresHowever pay particular attention to the following NOTEFrom this point if water tank
trap is broken the jet pump unit and engine removal will be required Withdraw jet pump unit assay,refer to "PROPULSIONDRIVE
SYSTEMS, section 08 30,43,47,48, Hook, Water Tank Trap, Tow Rear Bracket, Front Bracket Install bracket "A"291 000 214) on
tow hook and apply Locti1te 271293 800 005) on treads then reinstall nuts Apply Sikaflex primer 449293 530 012) on water