Bombardier SeaDoo 1990 factory shop manual, Page 176Get this manual

Bombardier SeaDoo 1990 factory shop manual, Page 176

Section STORAGE 1 Remove and clean the battery Apply some dielectric grease293 550 0041 or petroleum jelly on battery posts
pipe and temporarily tie them together Insert funnel into inlet hose going to the water inlet socket at enginePour about
two liters (112 gal) of antifreeze solution through the funnel Tie up all hoses higher than tuned pipe CAUTIONAlways use
ethyllene-alcohol antifreeze containing corrosion inhibitors specifically recommended for aluminum engines NOTEThe engine
will not have to run during this operation NOTEIf hoses are not attached higher than turned pipe, coolant will drain out
Water inlet hose going to engine Four hoses have to be disconnected to allow air to escape and antifreeze solution to completely
fill cooling system water jackets Disconnect the hoses where shown Hold hoses high,er Page: 176 See Doo 1990 Shop Manual