Bombardier SeaDoo 1992 factory shop manual, Page 46Get this manual

Bombardier SeaDoo 1992 factory shop manual, Page 46

Section 03 ENGINE Sub-section 02 (REMOVAL AND INSTALLATION) COMPONENTS 1 Hexagonal nut M8 t4f Lock washer M8 14) Tuned pipe
:To release clamp from cooling hosefuel line, use pliers295 070) REMOVAL FROM WATERCRAFT In order to remove engine from watercraft
proceed as followsPropulsion System To withdraw jet pump unit ass'y, refer to PROPULSION AND DRIVE SYSTEMS, 08-01 then refer
to removal and overhaul Electrical Connections WARNINGAlways disconnect starter or battery cables exactly in the specified
order, black negative cable firstElectrolyte or fuel vapors can be present in the engine compartment and spark might ignite
them and possibly cause personal injuriesIt is recommended disconnect electrical connections prior disconnecting fuel linesFirst,
remove black negative cable from battery, then red positive cable Remove battery holding straps then withdraw battery Disconnect
thermosensor wire and spark plug cables Disconnect hose from water outlet socket on engine DISconnect inlet hose, injection