Bombardier SeaDoo 1992 factory shop manual, Page 53Get this manual

Bombardier SeaDoo 1992 factory shop manual, Page 53

Section 03 ENGINE Sub-section 03 (TOP END) COMPONENTS 1 10 12 13 14 75 16 Alien screw M6 (2) Lock washer7) Sensor switch
on carburetor sidePivot intake silencer to rear of watercraft Remove both retaining screws carburetor support from engine
coverRemove screws holding flame arrester cover, then withdraw coverRemove throttle and choke cables from flame arrester
baseRemove screws from flame arrester base, then withdraw baseRemove spark plug cables and connect them on the grounding
deviceDisconnect thermosensorwire Remove cylinder head coverIf shells, sand, salt or any other particles arepresent in cylinder
head, clean with vacuum cleanerRemove screws then cylinder headIf shellls, sand, salt water or any other particles are present
in cylinder cooling jacket, clean with vacuum cleaner Remove screws then pull cylinder up, being careful that connecting
rod does not hit crankcase edge WARNINGi screws need to be heated for removal when engine is in watercraft, fuel system pressurization
must be done firstDo not use open flameuse heat gunA explosion rnilght occur since vapors can be present in engine compartmentNOTEEven