Bombardier SeaDoo 1992 factory shop manual, Page 74Get this manual

Bombardier SeaDoo 1992 factory shop manual, Page 74

Section 03 ENGINE Sub-section 05 (BOTTOM END) INSPECTION Visually inspect parts for corrosion damageInspect plane surfaces
NEW PARTS (min.1 4rnax.l WEAR LIMIT, Crankshaft deflection Connecting rod big end axial play 737 mrn 029 in) Connecting Rod
Straightness Align steel ruler on edge of small end connecting rod boreCheck if ruller 11s perfectly aligned with edge of
big endL F001 003 061 extractor Ruler must be aligned with edge of connectina rod here 7If bearings are to be replaced, they
can be NOTE quickly removed using an air hammerCLEANING Discard all oil seals, gaskets, 0-nngs and sealing ringsClean water
and oil passages and make sure thley are not clogged Clean all metal components in solventRemove old Loctite from crankcase