Bombardier SeaDoo 1992 factory shop manual, Page 98Get this manual

Bombardier SeaDoo 1992 factory shop manual, Page 98

Section 04 COOLING SYSTEM SEA-DOOWATERCRAFT COOLING SYSTEM Uppermost point of circuit allows trapped air escape Fresh water
Self-bleed type (hose at uppermost point of circuit and cylinder head cover1 Self-drain type (hose at lowest point of circuit)
A flush kit is available System bleeding System draining System flushing Overheat beeper Turns on at 96-99OC Check joints
for leaks to avoid water accumulation in the bilgeFlush cooling system after each operation salt water or unclean waterDo
not modify hose or socket size as coolant flow could be alteredsmall stream of water must flow from the rear bleed outletlslThis
indicates that coolant is circulating 1205-2lO'FI Water injected directly into exhaust gas for noise reduction and performance
improvement Ootional flush kit to be used with a calibrated fitting Drain line minimize loss of cooling water) See Doo 1992