Bombardier SeaDoo 1992 factory shop manual, Page 100Get this manual

Bombardier SeaDoo 1992 factory shop manual, Page 100

Section 04 COOLING SYSTEM Sub-Section 03 (FLUSHING AND CARE) NOTEIf flush kit is not installed on watercraft, disconnect
flow through the tuned pipe into the engine and may cause darnage internal partsOpen water tap imt mediately after engine
is started prevent overheatingFolllow this procedure exactly4 Run the engine about five minutes at fast idle around 3500
RPMCAUTIONNever run engine longer than five minutesDrive line seal has cooling when watercraft is out of water5 Close the
water tap then stop the engine CAUTION :Always close the water tap before stopping the engineFollow this procedure exactly
otherwise severe engine damage could occur6 Disconnect garden hose from outlet hose and connect hose to exhaust socket7 Wipe
off any residual water on the engine, 2Check joints for leaks to avoid water accumulation in the bilge 8 Reinstall seat and