Bombardier SeaDoo 1992 factory shop manual, Page 145Get this manual

Bombardier SeaDoo 1992 factory shop manual, Page 145

Section 07 ELECTRICAL Sub-section 04 (ELECTRIC STARTER) REMOVAL Disconnect black cable ground connection from battery 2,3,4,
CAIUTION :Yoke ass'y and drive ulnit assembly must not be immersed in cleaning solventDiscard all O-rings and gasketClean
brushes and holders with clean cloth soaked in sollventBrushlesmust be dried thoroughly with clean clothRemove starter support
nuts then through boltsSeparate end frame from yoke assembly Withdraw yoke assembly from armatureBrush holder can be removed
from end frame by unscrewing nut retaining terminalCheck that the radial play between the armature shaft and end frame is
not greater than 0.20 mm t.008 in)Replace end frame if soBlow brush holders clean using compressed air WARININGAlways wear
safety glasses when using compressed air Remove dirt, oil or grease from commutator using clean cloth soaked in suitable
solventDry well using clean, dry clothClean engine ring gear teeth and drive unit (clutch) NOTEBushings must not be cleaned