Bombardier SeaDoo 1992 factory shop manual, Page 146Get this manual

Bombardier SeaDoo 1992 factory shop manual, Page 146

Section 07 ELECTRICAL Sub-section 04 (ELECTRIC STARTER) INSPECTION Armature NOTEAn ohmmeter may be used for the following
New brush length is 12 mrn 4.472 in) Overrunning Clutch Check commutator out of round condition with V-shaped blocks and
an indicatorIf commutator out of round is more than 0.40 mm (.016 in), commutator should be turned on latheCheck commutator
outer diameterIf less than 27 mm (1.063 in)replacePinion of overrunning clutch should turn smoothly in clockwise direction,
and should not slip in counterclockwise directionIf defective, replaceCheck pinion teeth for wear and damage If defective,
replalce NOTE: Always check engine ring gear teeth for wear and damageIf defective replace ring gear Refer to ENGINE 03-04
then refer to ring gear Starter Switch Switch condition can be checked with an ohmmeter Install test probes on both BLACKlWHITE
wires of switchMeasure resistance, it should be high when button is released and must be close to zero (0) ohm when activated