Bombardier SeaDoo 1992 factory shop manual, Page 158Get this manual

Bombardier SeaDoo 1992 factory shop manual, Page 158

Section 07 ELECTRICAL Subsection 06 (CDI AND CHARGING SYSTEMS) Engine StopJTether Cord Switchles Verification Engine Stop
Ignition Relay Verification The relays which are installed on MPEM are identical, but they are different in function The
one located near the module center is the one for the ignition system The ignition relay is working off 20 second timer delay
and could be the problem of some faulty ignition situations Charging system relay (relay #I) Ignition system relay Reinstall
ignition relay to verify if current goes through the relayConnect multirneter test probes, one into PURPLE wire and the other
to groundInstall tether cord and touch starter buttonA reading should be supplied to multimeter through the PURPLE wire from
relay power source (battery voltage) CAUTION :To measure voltage at PURPLE wire, BLACKlWHITE wire must be connected solenoid
negative and YELLOWRED wire connected to solenoid positiveA voltage test ca be performed to verify if power is going to the