Bombardier SeaDoo 1992 factory shop manual, Page 163Get this manual

Bombardier SeaDoo 1992 factory shop manual, Page 163

Section 07 ELECTRICAL Subsection 06 (CDl AND CHARGING SYSTEMS) BATTERY CHARGING SYSTEM GENERAL Magneto It is the primary
prevent any damage to components terminal TESTING PROCEDURE NOTEFirst, ensure that battery is in good condition prior to
performing the following test - Disconnect positive cable from battery Current Test Proceed as follows- Start engine NOTEStart
engine before connecting cablesOtherwise ammeter may be damaged as current flow is much higher startingatConnect jumper wire
between battery positive post and ammeter- Connect second jumper wire between ammeter and positive cable terminal ositive
cable - Bring engine to approximately 5500 RPMDepending on battery charge, current reading should be approximately (amperes).If