Bombardier SeaDoo 1992 factory shop manual, Page 179Get this manual

Bombardier SeaDoo 1992 factory shop manual, Page 179

Section 08 PROPULSION AND DRIVE SYSTEMS Sub-section 01 (PROPULSION AND DRIVE SYSTEMS) CAUTIONBe careful not to damage hull
turnbucklie is needed to apply extension force between ride shoe and hullUse 25 mm (1 in) square tube by approximately 125
mm (5 in) long so that, with all parts welded, its overall length will1not exceed 190 mrn (7-112 in)- On one end, weld 10
(38 dianut in)Weld the head of 10 100 mrn (318 in) screw on top of one angle bar then screw in square tube- lnsert 10 15
mrn (318 12 in) screw through large and thick washer or suitable sleeve - Install a 37,38,39,40,41, Shoe, Screw anld Glrill
Ride NOTEGrill must be removed prior to removing ride shoeImpelller housing must be removed to allow ride shoe removal nut
on screw Do not fullly tighten, ensure screw can easily rotate into washer Weld the top of other angle bar to nut Page: 179