Bombardier SeaDoo 1992 factory shop manual, Page 189Get this manual

Bombardier SeaDoo 1992 factory shop manual, Page 189

PROPULSIOIN AND DRIVE SYSTEMS Sub-Section 01 (PROPULSION AND DRIVE SYSTEMS) Section 08 Manually engage ring in housing making
press only, push tool until tool flange contacts housingProceed the same for both bearings If press is not readily available,
piece of wood such as 12 in long, can be usedManually engage ring in housing making sure it is equally inserted all aroundPlace
wood piece over nngUsing hammer, strike on wood to push ringStrike one side then rotate wood piece about 90' and strike againWork
this way, frequently rotating wood piece so that ring slides eqlually all around until it seats into bottom of housing CAUTION: