Bombardier SeaDoo 1992 factory shop manual, Page 190Get this manual

Bombardier SeaDoo 1992 factory shop manual, Page 190

Section 08 PROPULSION AN1DDRIVE SYSTEMS Sub-section 01 (PROPULSION AND DRIVE )- CAUTIONThis tool has been designed properly
used to install seal in housingSeal must be installed so tlhat raised edges of llips are toward outside of housing (toward
impeller) Apply Loctite 515 (PIN 293 800 007)in seal housing, all around outer diameter and on seal seat Properly insert
seal on tool NOTEBe careful when installing seals to pack seal with grease before inserting bearinglseal installer tool Properly
insert tool in seal with rotating movement Raised edge of seal lip this side 7,8,9,10,26, Impeller Housing, Thrust Washer,
Thrust Bearing, Impeller Shaft and Impeller Ilnsert flat edgles of impeller shaft in vise so that shaft is verticalApply
synthetic grease 293 550 010) both sides of thrust bearing then insert onto shaft followed by thrust washerProperly center
washer and bearing with shaft flangeGrease will prevent parts from sliding at installation and thus possibly wedging thrust