Bombardier SeaDoo 1992 factory shop manual, Page 197Get this manual

Bombardier SeaDoo 1992 factory shop manual, Page 197

Section 08 PROPULSION AND DRIVE SYSTEMS Sub-section 01 (PROPULSION AND DRIVE SYSTEMS) Make sure rubber damper is on drive
shaft to properly index splinesMake sure boot is well positioned over shaft end If necessary, tap pump end with rubber hammer
until retaining nuts and washers can be installedApply Inctite 242 (blue) 293 800 015) on threads and equally tighten nuts
in criss-cross sequence and torque to 35 Nm (26 lbfft Secure boot clamp as foliowsUse pliers 295 000 069) as for removal
Closing hooks F001 009 083 - Squeeze pliers to draw closing hooks togletherWhen both large and small windows are directly
over the two locking hooks, press those windows down to engage and sea! clamp - Manually engage holding hook in large windowThis
is pre-clamping position onlyPRE-CLAMPING POSITION Holding hook Large window F001 009 075 Push windows Using grease gun,