Bombardier SeaDoo 1992 factory shop manual, Page 221Get this manual

Bombardier SeaDoo 1992 factory shop manual, Page 221

Section 10 HULLIBODY Sub-Section 01 (HULLIBODY) Water TankTrap 13,24, Rear Baffle and Vent Hose Remove air silencer, exhaust
surfacesnot necessary to remove all the glue but it is important to have smooth surfaces in order to get good adherence WARNINGThe
fuel valve must be set OFFRemove fuel cap slowlyFuel may be under pressure and might spray out when removing capFuel is flammable
explosive under certain conditionsAland ways work in well ventilated areaDo not smoke or allow open flames or sparks in the
vicinityAlways wipe off any fuel spillage from the watercraftRemove tow hook nutsNOTEFrom this point if water tank trap is
broken the jet pump ulnit alnd engine removal will be requiredWithdraw jet pump unit assry, refer to PRO1PULSIION AND DRIVE
SYSTEMS 08-01 then look for removalWithdraw engine, refer to ENGINE 03-02 then look for removal NOTE :It IS Installation
is essentialllythe reverse proceduresHowever pay particular attention to the following 30,43,47,48, Tow Hook, Water Tank
Trap, Rear Bracket and Front Bracket Install bracket291 000 2141 on tow hook and apply Indite 271 (PIIN 293 800 005) on treads