Bombardier SeaDoo 1992 factory shop manual, Page 234Get this manual

Bombardier SeaDoo 1992 factory shop manual, Page 234

Battery Refer to BATTERY 07-03 then look for removal to remove and clean the batteryApply some dielectric grease (PIN 293
Protection1 Cooling system may be filled with 50 50 water antifreeze solutionCAUTIIONAlways use ethylene-gllycol antifreeze
containingcorrosion inhibitors specifically recommended for aluminum enginesNOTEThe engine will not have to run during this
operationThree hoses have to be disconnected to allow air to escape and antifreeze solution to completely fill cooling systern
water jackets Install hose pincher on water injection hose Raise all hoses above the highest point of tuned pipe and temporarilly
tie them togetherInsert funnel into inlet hose going to the water inlet socket at tuned pipePour about liters (112 gal) of
antifreeze solution through the funnelTie up all hoses higher than tuned pipe nIf hoses are not attached higher than tuned