Bombardier SeaDoo 1993 factory shop manual, Page 43Get this manual

Bombardier SeaDoo 1993 factory shop manual, Page 43

Section 03 ENGINE Sub-section 01 (WATER-FLOODED ENGINE) WATER-FLOODED ENGINE ENGINE DESCRIPTION The two stroke ROTAX engine
bilge if water is presentRemove engine crankcase drain plugs located underneath oil injection pumpOil injection 1003 008
Drain plugs Remove spark plug cables and connect them on the grounding deviceWARNINGNever crank engine with spark plugs removed
unless spark plug cables are connected to the grounding device Remove spark plugs and dry with clean dry clothA contact cleaner
spray can be used, it may be preferable to replace spark plugsDo NOT install spark plugs on engineCrank engine to drain crankcaseNOTEWhenever
the engine is stopped more than 20 seconds, the electrical system has to be reactivated by touching starter buttonCAUTIONBe
careful when cranking engine, water will spray out from spark plug holesReinstall crankcase drain plugsCAUTIONCrankcase drain
plugs should have Loctite PST 592 (P293 800 018) applied threads before reinstallingCrank engine again to allow any remaining