Bombardier SeaDoo 1993 factory shop manual, Page 114Get this manual

Bombardier SeaDoo 1993 factory shop manual, Page 114

Section 05 FUEL SYSTEM Sub-section 03 (CARBURETORS) If release pressure is not within specification, check control lever
conditionsAlways inspect spark plug tip condition when dealing with pilot jet and main jetSpark plug tipcondition gives good
indication of carburetor mixture settingCAUTIONAdjustments vary with temperature and altitudeAlways observe spark plug condition
for proper jettingNOTETo have access to pilot jet or main jet, check valve housing must be removed NOTEPrior to check valve
housing installation, remember to set gasket 46,47, Diaphragm and Cover Install diaphragm with its integrated O-ring into
carburetor grooveMake sure that the tab of cover is inserted into carburetor notchd 32,54, O-ring When installing O-rings
of low-speed mixture screw and main jet screw, apply some SEA-DO0 LUBE (P293 600 006)to prevent sticking CalrburetorMount
Nuts Install lock washers and apply Loctite 242 293 800 015) on threads then torque nuts to 25 Nm (18 Ibfft) Fuel Lines and
Hose Clamps Iffuel line ends are damaged, cut damaged end before reinstallationProperly tighten clamps with special pliers295