Bombardier SeaDoo 1993 factory shop manual, Page 119Get this manual

Bombardier SeaDoo 1993 factory shop manual, Page 119

Section 05 FUEL SYSTEM Sub-section 03 (CARBIURETORS) ' - Remove wave pin from reverse shaft and unscrew reverse handleRemove
is no obstructions in threaded holes of fuel sensor adapter' Slide fuel sensor adapter on fuel sensorAlign sensor holes with
adapter holesWARNING :A good hole alignment is necessary WARNING : Do not over torqueTorque wrench tightening specifications
must be strictly adhere toNOTEIt is normal to have small and even deformation all around fuel sensor adapter Apply some Loct'rte
242 (blue) on the five screws, install washers and hand tighten to eliminate play between sensor and adapterHand tighten
the five screws Small and even deformation Torque screws in criss-cross sequence to 1.5 Norn (14 Torque applied to materials
such as rubber, plastic and fiberglass will decrease automaticallyThe torque reduction is caused by material creepingThis