Bombardier SeaDoo 1993 factory shop manual, Page 172Get this manual

Bombardier SeaDoo 1993 factory shop manual, Page 172

Section 07 ELECTRICAL Sub-section 06 (CDI AND CHARGING SYSTEMS) 1NOTEThe fuses connectors are directly mounted onto the MPEMEngine
with tester from Superex Canada Ltd part number 15-785The first three items can be chlecked with known automotive equipment
and other items as followsNOTE :To perform verification good quality multimeter such as Fluke 73 (P529 022 000) can be used
Engine StopTether Cord Switches Verification Both switches can be verified together because they are connected in seriesDisconnect
stop switch BLACK wire in ellectrical boxDisconnect tether cord switch BLACKYELLOW wire from MPEM BLACKYELLOW wire in electrical
boxUsing an ohmmeter connect test probes to BLACK and BLACKYELLOW wiresInstall tether cord cap over the switch and if the
reading is infinity (-1, verify both swicthes separatelyProceed as followsEngine Stop Switch Disconnect the BLACK and BLACKYELLOW
wires in the electrical boxUsing an ohmmeter, connect test BLACKYELLOW wiresprobes to switch BLACK and Measure resistance,