Bombardier SeaDoo 1993 factory shop manual, Page 177Get this manual

Bombardier SeaDoo 1993 factory shop manual, Page 177

Section 07 ELECTRICAL Sub-section 06 (CDI AND CHARGING SYSTEMS) Magneto and Generating Coil Output (Single Coil) 1Disconnect
BLACK ofmagnetoharness FOOT DOT 101 3Start engine and observe indicator4Push reset button and repeat step twiceResultsa)
Indicator lamp lightsIgnition generating coil output is up to specificationsb) Indicator lamp does not lightThe problem is
faulty ignition generating coilReplace it 3Start engine and observe indicatorNOTEIf engine starts, allow it to idle while
observing indicatorThen, shut engine off4Push reset button and repeat step twice Results : a,) Indicator lamp lightslgntion
is OKcoil b) Indicator lamp does not light on one or both cylinder(3)Ignition cod is faultyReplace it Ignition Coil Output