Bombardier SeaDoo 1993 factory shop manual, Page 182Get this manual

Bombardier SeaDoo 1993 factory shop manual, Page 182

Section 07 ELECTRICAL Sub-section 06 (CD1AND CHARGING SYSTEMS) BATTERY CHARGING SYSTEM GENERAL Magneto it is the primary
prevent any damage to components Tester wires Component wires YELLOW of magneto harness YELLOWBLACK of magneto harness Tester
Tester dial switch position position TESTING PROCEDURE NOTEFirst, ensure that battery is in good condition prior to performing
the following test using current indicator such as Snap-on MT 110 Current Test Proceed as follows, - Start engine Install
tester over battery positive cable Bring engine to approximately 5500 RPMDepending on battery charge, current reading should
be approximately (amperes).If not, check magneto output prior to concluding that rectifier is faulty Voltage Test Proceed
as follows- Start engine- Connect voltmeter (set on DC volt scale) on battery posts- Bring engine to approximately 5500 RPMIf
voltmeter reads over 15 volts, regulator is defectiveReplace itNOTEWhatever the voltmeter type used (peak voltage or RMS),the