Bombardier SeaDoo 1993 factory shop manual, Page 188Get this manual

Bombardier SeaDoo 1993 factory shop manual, Page 188

Section 07 ELECTRICAL Sub-section 08 (INSTRUMENTS) Oil Level Sensor Verification The oil level sensor completes the ground
resistance test should be performed with an ohmmeter between BLACKPURPLE and PURPLE wire terminalsThere should be no resistance
(0ohm1 between terminallsIf resistance is noticed sensor is defective CAUTIONWhenever connect in wires, never connect RED
PURPLE and RED wires togetherDamage could occur to rnulti-purpose electronic module To verify speed sensor resistance test
should be performed with an ohmmeterDisconnect speed sensor wires from inside bilgeRefer to the following chart for speed
sensor testingAlways respect polarity in chartMeter (-1 lead Meter (+) lead Apprcixvalue red brown blackbrown black brown