Bombardier SeaDoo 1993 factory shop manual, Page 193Get this manual

Bombardier SeaDoo 1993 factory shop manual, Page 193

Section 08 PROPULSION AND DRIVE SYSTEMS Sub-section 01 (PROPULSION AND DRIVE SYSTEMS) COMPONENTS 7Flat washer M6 2Ffttfng
assembly Seal (single hp) Seal carrier Needle bearing Sea (double hp) Damper Driveshaft Wing nut M8W Flat washer M8 (21 PTO
Flywheel guard LOCtite 14 super bonder Drive shaft assembly Protective hose Gear clamp (21 Locking disk (2)(58065807,5808
models) Shim Stud M8 15 Hull insert Locate 732 RTVsthcone Lock washer M8 CounFersunk Phillips screw M5 (6) (5852 model) DilsconnectbatteryWARNINGBattery
black negativecable must always be disconnected firstand connected last JET PUMP SERVICING NOTEThis portion outlines some
routine proceduresTo obtain complete information con,cerning these procedures, inspection, parts, iilustrations, sealing
thread locking products, tightening torques etc, refer to REMOVAL AND OVERHAUL and following portionTo work on watercraft,
securely install it on standThus, if access is needed to water inlet areait will be easy to slide underneath watercraftWorking