Bombardier SeaDoo 1993 factory shop manual, Page 197Get this manual

Bombardier SeaDoo 1993 factory shop manual, Page 197

Section 08 PROPULSION AND DRIVE SYSTEMS Sub-Section 01 (PROPULSION AND DRIVE SYSTEMS) Use threaded rod 19 170 mrn (314 N.Cx
mat or similar protective material on support to prevent scratching hull rear section FOCI 011 094 Use one steel flat bar
38 13 mm (1-112 12 in) thick 115 rnm (4-12 in) long or two flat bars mrn (14 in) thick welded together- Drill one 21 mm (13116
in) diameter hole in center of flat bar- Align two 19 mrn (34 in N.C diameter nuts over the hole already drilled in flat
bar and weld them in place- Use two steel flat bars 38 rnm (1-12 114 in) thick 70 mrn (2-34 in) long- Weld two pieces of
cold rolled steel 22 mrn (718 in) diameter 10 mrn (38 in) thick on each flat bar the center end- Drill one mrn (2164 in)