Bombardier SeaDoo 1993 factory shop manual, Page 202Get this manual

Bombardier SeaDoo 1993 factory shop manual, Page 202

Seaion Q8 PROPULSION AND DRIVE SYSTEMS Sub-section 01 (PROPULSION AND DRIVE SYSTEMS] To remove impeller, apply rotating
lugCut wear ringNOTEWear ring can be cut using jigsaw, small buffer or low clearance hacksaw such as Snap-on HS3 or equivalentCAUTIONWhen
cutting ring, be careful not to damage impeller housing NOTE: if bearings and seal need to be renewed, the special pusher
described further an in bearing removal can be usedSimply nsert pusher from the rear and push towards the front Same too[
as far beari gs, rernovall Pushing seal and bearings out from rear If onlly seal needs to be renewed, proceed as fallows: