Bombardier SeaDoo 1993 factory shop manual, Page 204Get this manual

Bombardier SeaDoo 1993 factory shop manual, Page 204

Section 08 PRaPULSIQNAND DRIVE SYSTEMS Sub-Section 01 (PROPUILSION AND DRIVE SYSTEMS) Discard all O-rings and clean parts
instead of special tool (P 295 0100 QQ11Refer to ENGINE 03-04 then look for PTO flywheel and magneto CLEANING fitting can
be removedto ease cleanling of impeller housing mating surfaceMost silicone can be removed with scraper such as Snapon #CS-Al2Remaining
silicone can be removed with steel brush (disc) mounted on drillcan Bornbardier stripper (P 295 000 040) be used to remove
rernaining siliconeCarefully apply on mating surfaces taking care not 10 exceed this area because paint will be damagedLet
product dissolve silicone then scrape itProperly clean all threads NOTEBailer tube fittings and cooling supply 51,53,54,
Needle Bearing, Damper and Drive Shaft Wear Visually inspect shape of dampers for deformation or other damageEnsure they
are firmly retainedInspect seal carrier needle bearing and its contact surfaceCheckfor scaring, pitting, chiplping or other