Bombardier SeaDoo 1993 factory shop manual, Page 212Get this manual

Bombardier SeaDoo 1993 factory shop manual, Page 212

Sectioln 08 PROPULSION AIND DRIVE SYSTEMS Sub-section 01 (PROP'ULSION AND DRIVE SYSTEMS) Impeller remover295 000001) Pressure
PUMP PRESSURIZATION Whenever doing any type of repair on the pump, pressure test should be done to check for any leakage
CAUTIONRepair any leak, failure to correct leak will lead premature wear of pump complonentsIf there is pressure drop spray
soapy water around housing coverIf there are no bubbles, impeller shaft, impeller shaft seal, or impeller housing is Ileaking
through porosity and has to be replacedJet pump unit has to be overhaulledPlace housing horizontally as in its operating
position so that fitting in cover is located in topRemove fitting from coverPour SEA-DO0 JET PUMP SYNTHETIC OIL (P 293 600
0111 in reservoir until oil comes level with bottom of holeLet oil penetrates in housing and after few minutes pour oil again
until it level with bottom of holeOil capacity is 65 mL (2.2 oz)CAUTIONThis is synthetic oilDo not mix with mineral based