Bombardier SeaDoo 1993 factory shop manual, Page 226Get this manual

Bombardier SeaDoo 1993 factory shop manual, Page 226

Section 08 PROPULSION AND DRIVE SYSTEMS Sub-Section 03 (VARIABLE TRIM SYSTEM (VTS)) COMPONENTS Housing Gasket Hexagonal screw
is not necessary to remove variable trim system (VTS] from watercraft for servicingHowever, variable trim system removal
is necessary to replace either worm, sliding collar, housing gasket and housing Sliding DISASSEMBLY In order to obtain an
easy access to either trim cable or electric motor, remove storage basket from watercraftDisconnect batteryWARNINGBattery
black negative cable must always be disconnected first and connected last Electric Motor To replace motor, disconnect wiring
harness and remove screws holding motor to motor supportNOTEAt removal, the motor adaptor and its seal might come off Remove
ball joint from trim ring then unscrew ball joint from cableRemove half rings, ring retainer and rubber washer from calble
at the outside of hulllPull out cable from inside the hull 5, Trim Cable To replace trim cable, remove nut from the end of