Bombardier SeaDoo 1993 factory shop manual, Page 256Get this manual

Bombardier SeaDoo 1993 factory shop manual, Page 256

Section 10 HULLBODY Sub-section 01 (HULL BODY) Removal Using heat gun warm up one end of decal for few seconds until decal
decal will be locatedFor better adhesion dry application is recommended, however, to ease decal installation mild solution
of soapy water can be sprayed over surface where decal will be installedRemove back protective film from decal and align
decal with marksWhen well aligned squeegee decal beginning at center and working outward using, firm, short, overlapping
strokesRemove front protective film once decal has adhered to hullInstallation on plastic (storage cover) Clean surface with
isopropyl alcoholUsing pencil and the decal as template, mark the area where decal will be locatedApply an activator (P 293
530 036)to prepare the surface using clean clothAfter few seconds, when the activator evaporates, the surface is readyCAUTION
:Do not use soapy water to locate decal on plastic partsRemove back protective film from decal and carefully align decal
with marksWhen well aligned squeegee decal beginning at center and working outward using, firm, short, overlapping strokesRemove