Bombardier SeaDoo 1993 factory shop manual, Page 258Get this manual

Bombardier SeaDoo 1993 factory shop manual, Page 258

Section 10 HULLBODY Su b-Section 02 (INFLATABLE TUBE) Tears Repair of More than cm (2 in) For best results, repairs should
of adhesive (included in repair kit or use Bostik 2402-A with hardener 2402-6) to one patch and to inner section tubeAIIow
adhesive to dry so that it is dry to the touchNOTEMix Bostik glue and hardener as per instru,ctionon its packageApply second
thin layer of adhesive on both partsAllow the second coat to dry until tacky to the touch; then, position the patchNOTETo
ease patch installation, roll it tightly and insert it through the tube tearSmooth out the patch using spoon-shaped tool
beginning at center and working outward to remove all excess glue and air bubblesRepeat the same bonding procedure for the
outer patch Allow 24 hours to dry before inflatingClean any glue excess Clean tube surface with solvent such as methylethyl
ketone, toluene or acetoneSand thoroughly tube area and the new handle with 80 grit sandpaperNOTEProtect tube surface in
vicinity with masking tapeRemove masking tapeClean the handle and tube areas with solvent such as methylethyl ketone, toluene