Bombardier SeaDoo 1994 factory shop manual, Page 55Get this manual

Bombardier SeaDoo 1994 factory shop manual, Page 55

Section 03 ENGINE Sub-Section02 (REMOVAL AND INSTALLATION) CLEANING Wipe off alny spillage in bilgeCllean with bilge cleanerDliscard
remove rubber mounts one at time and reinstall each shim to its original location 9,211, Engine Support and Nut Properly
install support on crankcase so that rounded portion of support matches with MAG side of crankcaseApply Loctite 242 (blue)
on threads then torque nuts in criss-cross sequence to 35 Nm (26 lbfmft)f- Rotary Valve Supply Line Make reinstall lines
before completely lowering sure bilgeengine in NOTEIf fuel line ends are damaged, cut damaged ends before reinstaltation,
For fuel line ctamping, use special pliers (P295 000 054) EnlgineJet Pump Alignment Alignment is necessary to eliminate possible
vibration andor damage to componentsCheck alignment of engine using alignment toolALIGNMENT TOOL P6N296000089) CAUTIONIf
shims with different thickness are interchanged, engine and jet pump will be misalignedNOTE :If shims location have been