Bombardier SeaDoo 1994 factory shop manual, Page 106Get this manual

Bombardier SeaDoo 1994 factory shop manual, Page 106

Section 04 COOLING SYSTEM Sub-section 03 (FLUSHING AND CARE) 587 ENGINE Fitting Coupler hose Hose piricher 6Run the engine
fitting spigot9Wipe off any residual water on the engine10Reinstall seat and properly latch 1 When servicing hull jet pump,
always rotate water- craft counterclockwise (seen from the rear)Rotating watercraft clockwise could allow residual water
in tuned pipe to enter the engine and cause damage657 ENGINES Coupler 5Start the engine then immediately open the water tap
CAUTIONAlways start the engine before opening the water tapOtherwise, water will back flow through the tuned pipe into the