Bombardier SeaDoo 1994 factory shop manual, Page 118Get this manual

Bombardier SeaDoo 1994 factory shop manual, Page 118

Section 05 FUEL SYSTEM Sub-Section 03 (CARBURETORS) Diaphragm must stand pressure for 10 secondsIf pressure drops, replace
on needleThis could damage valve seatneedle CARBURETOR ASSEMBLY Wnen assembling pump, ensure to properly position components
together Refer to previous illustrations if necessary HIGH LEVER 8,17,72,75, Choke Plate and Throttle Plate When installing
butterfly onto shaft, close butterfly so that it centers into carburetor boreFirmly tighten screwsCAUTIONAlways apply Loctite
242 (blue) on screw threads prior to installing screwsLOW LEVER Depress here then pry up here 21639, Needle Valve Lever Inlet
Control Lever Rounded end of needie valve lever must be flush with surrounding metering chamber floor and not with body assembly