Bombardier SeaDoo 1994 factory shop manual, Page 132Get this manual

Bombardier SeaDoo 1994 factory shop manual, Page 132

Section 06 OIL SYSTEM Sub-Section 02 (OIL INJECTION PUMP) (TYPICAL) Reconnect banjo fittings with washer on each side and
hose (P295 500 0991 CHECKING OPERATION On Watercraft NOTEOilsupply must be full of oilSeebleeding procedure above Unscrew
banjo fittings from pump Start engine and stop it as soon as it fires Ensure that oil level in small oil lines is passed
the unpainted areaRepeat the procedure until this condition is attained if not, remove pump assembly and check the pump gear
for defects, replace as necessaryTest pump as describes below NOTE :Through normal use, oil level must not drop in small
tubesIf oil drops, verify check valve operation in banjo fittings Replace as necessary Bench Test The oil pump must be removed
out of watercrafi Connect hose filled with injection oil to main une fittingInsert other hose end in an injection oil container