Bombardier SeaDoo 1994 factory shop manual, Page 192Get this manual

Bombardier SeaDoo 1994 factory shop manual, Page 192

Section 08 PROPULSION AND DRIVE SYSTEMS Sub-section 01 (PROPULSION AND DRIVE SYSTEMS) clamp for later useFrom inside bilge,
hull and pump housing, be careful not to damage shimIf shim is not reinstalled engine and jet pump alignment will be altered
16,21,22,23,24,62, Screw, Sleeve, Bushing, Nozzle and Locking Disk (if applicable) Remove retaining screws, locking disks
(if applicable! and withdraw nozzle Push sieeves and bushings out of nozzle 6,7, Nut and impeller Housing Remove nuts retaining
impeller housing to hull Using screws previously removed from nozzle, install impeller housing remover tool [P295 000 113)