Bombardier SeaDoo 1994 factory shop manual, Page 196Get this manual

Bombardier SeaDoo 1994 factory shop manual, Page 196

Section 08 PROPULSION AND DRIVE SYSTEMS Sub-section 01 (PROPULSION AND DRIVE SYSTEMS) 13,14, Housing Cover and Screw With
insert special tool in impeller splinesRotate impeller remover tool counterclockwise and unscrew completely impeller Cut
wear ringNOTE :Wear ring can be cut using jigsaw, small buffer or low clearance hacksaw such as Snap-on HS3 or equivalent
CAUTIONWhen cutting ring, be careful not to damage impeller housing shaft too! CAUTIONNever use any impact wrench loosen
impellerTo remove impeller, apply rotating movement and puil at same time Slide impeller out of housing and remove tool from
impeller, Remove screws holding impeller housing to shaft holder Lift impeller housing away from impeller shaft Slide thrust
washer and thrust bearing off from shaft After cutting ring, insert screwdriver blade between impeller housing and one end