Bombardier SeaDoo 1994 factory shop manual, Page 197Get this manual

Bombardier SeaDoo 1994 factory shop manual, Page 197

Section 08 PROPULSION AND DRIVE SYSTEMS Sub-Section 01 (PROPULSION and DRIVE SYSTEMS) To remove seal, proceed as follows
puller end Work with small strikes otherwise claws will slip out As soon as seal begins to slide out, retighten claws always
maintain them tight against seal Continue pulling until seal is out Pulling seal out of housing FOCI DOS 036 NOTEIf bearings
and seal need to be renewed, the special pusher descrbed further on in bearing removal can be usedStlnply nsert pusher from
the rear and push towards the front Or, use Handle Hammer Claws Snap-on hammer puller including CJ93-1 CJ125-6 CJ93-4 Same