Bombardier SeaDoo 1994 factory shop manual, Page 198Get this manual

Bombardier SeaDoo 1994 factory shop manual, Page 198

Section 08 PROPULSION AND DRIVE SYSTEMS Sub-section 01 (PROPULSION AND DRIVE SYSTEMS) 4, Needle Bearing NOTEIt is always
scraper Bombardier stripper (P 295 500 110) can be used to remove remaining sealantCarefully apply on mating surface taking
care not to exceed this area because paint will be damagedLet product dissolve seatant then scrape it 22865 in) dia 28 mrn
(1 115 in) dia 345 rnm (13-12 in) F001 008 037 Properly clean ait threads Discard all 0-nngs and clean parts in solvent Carefully
check water passages (bailer pick-up, cooling system) and oil passagesBlow low pressure compressed air through them and make
sure they are not clogged Insert pusher into one bearing then push tool using arbor press until bearings are out However,