1999-2001 Yamaha Phazer 500 / Venture 500 service manual, Page 8Get this manual

1999-2001 Yamaha Phazer 500 / Venture 500 service manual, Page 8

IMPORTANT INFORMATION GASKETS, OIL SEALS, AND 0- RINGS 1 All gaskets, seals, andrings should be replaced when an engine is
facing outwards(In other words, the stamped letters must be on the side exposed to view When installing oil seals, apply
light coating of lightweight lithium base grease to the seal lipsOil the bearings liberally when installing Do not use compressed
air to spin the bearings dryThis causes damage to the surface of the bearings CIRCLIPS All circlips should be inspected carefully
before reassemblyAlways replace piston pin clips after one useReplace misshapen circlipsWhen installing circlip CD, make
sure that the sharp edged corner is positioned opposite to the thrust it receivesSee the sectional view LOCTITE After installing