2006-2008 Yamaha RS, Vector, Rage Factory Service Manual, Page 24Get this manual

2006-2008 Yamaha RS, Vector, Rage Factory Service Manual, Page 24

COOLING SYSTEMVALVE CLEARANCE ADJUSTMENT INSP ADJ Install the coolant filler capApply and lock the parking brakeStart the
the cooling system again, as described aboveNo air bubbles OK Pour coolant into the coolant reservoir until the coolant level
reaches the "COLD LEVEL" level mark a3Install: Rear bumper cover Rear bumper cover bolt: Nm (0.4 kg, 2.9 ft lb) VALVE CLEARANCE
ADJUSTMENT NOTE: Valve clearance adjustment should be made on cold engine, at room temperature When the valve clearance is
to be measured or adjusted, the piston must be at the top dead center (TDC) on the compression stroke1Drain: Coolant Refer
to "COOLING SYSTEM"2Drain: Engine oil Refer to "ENGINE OIL REPLACEMENT"3Remove: Oil tank Refer to "A.CMAGNETO ROTOR AND STARTER