2006-2008 Yamaha RS, Vector, Rage Factory Service Manual, Page 266Get this manual

2006-2008 Yamaha RS, Vector, Rage Factory Service Manual, Page 266

CRANKCASE Tighten the connecting rod nutsConnecting rod nut: 1st: 20 Nm (2.0 kg, 14 ft lb) Final: Specified angle 120 Replace
angle (120) WARNING When the nut is tightened more than the specified angle, do not loosen the nut and then retighten itReplace
the bolt with new one and perform the procedure again CAUTION: Do not use torque wrench to tighten the nut to the specified
angle Tighten the nut until it is at the specified angles When using hexagonal nut, note that the angle from one corner to
another is 60 Remove the connecting rod and big end bearings Measure the compressed Plastigauge width on the crankshaft pinIf