2006-2008 Yamaha RS, Vector, Rage Factory Service Manual, Page 288Get this manual

2006-2008 Yamaha RS, Vector, Rage Factory Service Manual, Page 288

WATER PUMP NOTE: Install the water pump seal with the mechanical seal installer and 40 and 50 mm bearing driver Before installing
Push down 4Install: Rubber damper holder Rubber damper 2 Before installing the rubber damper, apply tap water or coolant
onto its outer surface5Measure: Impeller shaft tilt Out of specification Repeat steps (4) and (5) CAUTION:Make sure the rubber
damper and rubber damper holder are flush with the impellerMaximpeller shaft tilt: 0.15 mm (0.0059 in) 1 Straightedge Impeller