2006-2008 Yamaha RS, Vector, Rage Factory Service Manual, Page 376Get this manual

2006-2008 Yamaha RS, Vector, Rage Factory Service Manual, Page 376

TIGHTENING TORQUE Parts to be tightened Primary sheave drive shaft assembly bolt Connecting rod and cap Balancer Balancer
25 2.5 18 0.7 5.1 23 2.3 17 45 4.5 32 23 2.3 17 Remarks Apply LOCTITE Apply the engine oilApply LOCTITE Apply LOCTITE Apply
LOCTITE Apply LOCTITE Apply LOCTITE 1: Tighten the cylinder head bolts to 15 Nm (1.5 kg, 11 ft lb) in the proper tightening
sequence, loosen and retighten the cylinder head bolts to 15 Nm (1.5 kg, 11 ft lb) in the proper tightening sequence, and
then tighten the cylinder head bolts further to reach the specified angle 6570 in the proper tightening sequence2: Tighten
the crankcase bolts to 20 Nm (2.0 kg, 14 ft lb) in the proper tightening sequence, loosen and retighten the crankcase bolts
to 20 Nm (2.0 kg, 14 ft lb) in the proper tightening sequence, and then tighten the crankcase bolts further to reach the
specified angle 120 in the proper tightening sequence3: Tighten the connecting rod nuts to 20 Nm (2.0 kg, 14 ft lb), and