2006-2008 Yamaha Snowmobiles Apex/Attak Factory Service Manual, Page 127Get this manual

2006-2008 Yamaha Snowmobiles Apex/Attak Factory Service Manual, Page 127

DRIVE CHAIN HOUSING INSTALLATION 1During installation, pay attention to the followingA Properly install the rubber seal onto
D 0.2 0.6 mm (0.008 0.024 in) : ESSO beacon 325 grease or Aeroshell grease #7A For the jackshaft and drive chain housing
installation, refer to "SECONDARYSHAFT" 2Install: Lever rod 3Adjust: Lever rod length Adjustment steps: Loosen the locknuts
Turn the lever rod in or out until the specified length is obtainedLever rod length: 27 mm (1.06 in) Tighten the locknuts