2006-2008 Yamaha Snowmobiles Apex/Attak Factory Service Manual, Page 210Get this manual

2006-2008 Yamaha Snowmobiles Apex/Attak Factory Service Manual, Page 210

CRANKCASE S Replace the connecting rod bolts and nuts with new ones CAUTION: Tighten the connecting rod bolts using the plastic-region
angle (120_) WARNING When the nut is tightened more than the specified angle, do not loosen the nut and then retighten itReplace
the bolt with new one and perform the procedure again CAUTION: S Do not use torque wrench to tighten the nut to the specified
angleS Tighten the nut until it is at the specified anglesNOTE: When using hexagonal nut, note that the angle from one corner